Herramientas Personales
Usted está aquí: Inicio Ingeniería Cartográfica, Geodésica y Fotogrametría 3D Scanning and Modeling

3D Scanning and Modeling

Se plantea una introducción a los sistemas de modelización tridimensional, permitiendo al alumno adquirir competencias en la adquisición de datos con equipos láser escaner 3D. Se aplica la metodología de estudio de casos.

3D Scanning and Modeling

Mercedes Farjas Abadía

Harald Sternberg

(HafenCity Universität Hamburg)

Carlos Acevedo

(HafenCity Universität Hamburg)

Dpto de Ingeniería Topográfica y Cartografía.

Escuela Técnica Superior de Ingenieros en Topografía, Geodesia y Cartografía.
Universidad Politécnica de Madrid.

Asignatura de libre elección impartida en el 2º cuatrimestre de la titulación de Ingeniero Técnico en Topografía.

Tratamiento de datos de la nube de puntos 3D escaner

Valora esta asignatura

 

Credits: 1,5.

Final revision: July 2009.

 

REQUIREMENTS

  • Second year student with basic knowledge of Topographic Methods.
  • Basic knowledge of English is recommended.

 

GENERAL DESCRIPTION OF THE SUBJECT

Introduction to three-dimensional modelling, providing students with practical experience in data capture with 3D laser scanner equipment, including case-study methodology.

 

OBJECTIVES: KNOWLEDGE AND SKILLS

  • Acquaintance with the fundamentals of 3D laser scanner measurement techniques.
  • Acquaintance with classification of 3D laser scanners.
  • Acquaintance with the different types of equipment available.
  • Acquiring skills in designing surveys with 3D laser scanners.
  • Acquiring basic skills in the use of data processing software.

 

TEACHING METHOD

The subject will be taught in the form of projects and case studies. Students will play an active role in data capture with laser scanners and elementary data processing of the point clouds obtained.

The course will be run jointly with the ATHENS Program.

 

TEST ACTIVITIES AND PRACTICAL TASKS

Students will be expected to carry out a final exercise including a description of the methodology and the equipment used in their assigned tasks.

 

Acciones de Documento
  • RSS Feed
  • Enviar esto
  • Imprimir esto
  • Marcadores (bookmarks)
Copyright 2009, Autores y colaboradores. Reconocer autoría/Citar obra. Abadía, M. F., Sternberg, H., Acevedo, C. (2010, February 17). 3D Scanning and Modeling. Retrieved May 29, 2017, from OCW UPM - OpenCourseWare de la Universidad Politécnica de Madrid Web site: http://ocw.upm.es/ingenieria-cartografica-geodesica-y-fotogrametria/3d-scanning-and-modeling. Esta obra se publica bajo una licencia Licencia Creative Commons Licencia Creative Commons